There are no special tools or procedures required. The internal components are all accessed by removal of the transmission pan and filter only. The entire lock up system can be installed by anyone with minimal mechanical skills. This pulls the converter out of lock up to allow the car to easily accelerate back up to speed before the lock up re-engages. We also include a cruise control style brake switch that works perfectly to disconnect the +12 volt power to the lock up module when the brakes are applied. Unlocking the torque converter is achieved by disconnection of the +12 volts, or the transmission downshifts out of 4 th gear. This connection stays active as long as the transmission is in 4 th gear and the circuit is completed. This completed circuit activates a 10 second delay timer that when finished, connects the ground signal to the torque converter lock up solenoid, thus locking the converter clutch in. Once the ground is established, that completes the circuit in the timing module which is receiving a +12 volt signal from the fuse panel. When the transmission has shifted into 4 th gear, the pressure in the valve body closes a pressure switch that then creates a ground input. The solution was a timing based module system that activates the converter only after the transmission has shifted into 4 th gear. It had to be simple to install, and most importantly it had to work without any interface from the driver. We wanted to create a lock up system that would work with any engine combination in any vehicle. Here at Bowler Performance we designed our lock up module with simplicity in mind. ![]() Some aren’t much more than the old toggle switch some are much more advanced and include adjustable parameters to dictate how and when the converter lock up is activated. There are several variations of lock up kits available on the market today. That was all fine and good unless you forgot to turn it on or off. ![]() The old school way was to tap into the case connector and manually turn it on or off via a toggle switch in the dash. This primarily had to do with what type of engine was being used with the transmission, as well as, under what circumstances the lock up needed to be turned on or off for maximum efficiency.Īs these transmissions gained popularity as transplants into hot rods and customs it became necessary to figure out a way to get the lock up to function when the original equipment was no longer being used. Sometimes it was just electrical and sometimes it was electrical and vacuum operated. When GM installed these transmissions in a particular vehicle they had a few different ways to activate the lock up for the converter. Many times it will seem as if the transmission has a 5 th gear or extra over drive when the converter locks up since it will typically reduce engine speed by about 300 RPM. It takes stress off the fluid coupling of the torque converter and it helps decrease the amount of heat being generated at higher cruising speeds. ![]() The GM 700-R4 & 200-4R transmissions utilize a lock up converter to help create a more efficient transmission. The lock up converter was introduced many years ago but due to the extra costs, it never gained popularity until the late 1970’s when the energy crisis demanded a more efficient operation of automatic transmissions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |